Ash Removal Device without Additional Ash Container

Product detailed description

- intended for DxxP pellet boilers

As an accessory for every DxxP pellet boiler manufactured after 1 March 2007, an automatic ash removal system from the boiler body to an additional external ash container can be purchased. This automatic ash removal device requires no special operation and increases the comfort of pellet heating.
Ash removal takes place fully automatically by means of a screw conveyor with a gearbox, which removes ash from the chamber below the burner at regular intervals of 1, 3, 6, 12 or 24 hours, depending on the setting for the specific fuel. Automatic ash removal can also be switched on manually if needed, simply by turning the switch on the boiler off and on again. The size of the ash container is chosen after careful consideration based on the ash content of the fuel.
When the additional ash container is completely full, the ash removal device (auger) is automatically shut off and the ash removal module starts to emit an audible signal. New commissioning is carried out after cleaning the external ash container (emptying it) simply by switching the switch on the boiler off and on again for 5 to 10 seconds.

Frequently Asked Questions

• How can I check that "Ash Removal Device without Additional Ash Container" fits my appliance exactly? The most reliable way is to compare the exact type/catalogue designation on your appliance's rating plate (boiler, tank, water heater) with the compatibility stated directly in this product's name (Atmos brand) and in its technical parameters above. If in doubt, send us the exact type designation of your appliance (including the serial number, if available) - we will gladly verify the compatibility for you.
• Why is it important to use an original/compatible part rather than a universal replacement? Parts such as gaskets, sensors or safety components (safety valves, thermal fuses) are usually dimensioned precisely for the parameters of a specific appliance (pressure, temperature, sensor electrical resistance) - the wrong part can cause reduced function, leaks, or, in the case of safety components, a genuine safety risk.
• Does this part have to be installed by a professional? For simpler, mechanical parts (e.g. gaskets, covers, small accessories with no connection to electricity, gas or the pressurised part), a handy DIY person can usually manage the replacement after disconnecting the appliance from power and the system. For any intervention in the gas, electrical or pressurised part of the appliance (e.g. sensors directly in the combustion chamber, safety valves, electrical modules), however, we always recommend a service technician - especially since such an intervention could affect the validity of the warranty on the whole appliance.
• How do I know this part is worn and needs replacing? Common signs are visible wear/cracking (for gaskets and rubber parts), water or flue gas leaking at the part, an error message on the control display (for sensors and electronic modules), or an obviously reduced function of the appliance (e.g. irregular combustion for burner parts). If in doubt, the safest option is to have the condition assessed by a service technician during the regular annual inspection.
• Is it worth keeping this part at home as a spare? For parts that are subject to regular wear (gaskets, fuses, small mechanical parts) and whose failure would mean a shutdown of heating or hot water production, keeping a spare on hand is a sensible precaution - especially for an older appliance, for which the part may be harder to source quickly.