Automatic home water pump station VESSER JET 100A with BRIO PC-13

Product detailed description

The automatic home water pump station VESSER JET 100A with PC-13 is used mainly seasonally, primarily for irrigation. Use and advantages of the VESSER JET 100A pump: pumping from wells where the suction depth does not exceed 8 metres supplying clean water to houses, cottages and similar irrigation high discharge head corrosion resistant easy operation BRIO PC-13 control unit type: Automatic switching on and off of the pump when the tap is opened / closed Built-in check valve and integrated dry-run protection Pressure gauge Rated current: up to 10A Operating voltage: ~ 230 V ± 10% / 50 Hz Connection: inlet and outlet, each with an external thread of 2.54 cm (G1") Maximum operating pressure: approx. 10 bar Maximum water temperature: approximately 60 °C Switch reset: manual Switch-on pressure range: 1.5 bar The switch-off pressure cannot be adjusted Flow rate: approximately 150 litres/min Dimensions (H x W x D): 15 x 13 x 23 cm Weight: approximately 1.3 kg Protection class: IP65 An electronic switch for monitoring pump operation, also known as a press control, provides the function of a pressure switch, enabling automation of the electric water pump's operation depending on the pressure drop and when water flow in the pipeline stops (i.e. when the device's electrical contacts open and close) - it enables self-operation of the pump or water pump station. The PC-13 press control with pressure gauge also provides dry-run protection - it switches off the pump when running without water. This protects the pump from damage that could occur when running without water. After switching off, it is put back into operation by pressing the RESET button. We recommend using the PC-13 press control with pressure gauge in clean water systems without impurities and sediments; otherwise a suitable filter must be installed on the inlet side of the device. A suitable alternative is also: the PC-16 control unit. Product advantages: The PC-13 press control with pressure gauge can be used as an automatic unit for pumps and water pump stations without a pressure vessel (automatic water pump station). A major advantage of the PC-13 control unit is its simplicity of use. The BRIO PC-13 control unit with pressure gauge - press control has a built-in check valve against backflow of water into the pump. Operation and basic data: The PC-13 automatic device with pressure gauge starts the pump for approximately 15 seconds at the moment of connection. The pump then starts every time the operating pressure is reached, at the moment the pressure in the system drops, for example when a valve is opened. Unlike other pressure switches and control units, which switch off when a certain pressure is reached, the PC-13 automatic device with pressure gauge switches off at the moment the minimum flow value is reached. When this condition is met, the device delays switching off the device by 7 to 15 seconds. This reduces the frequency of pump starts at low flow rates. Installation: The PC-13 automatic device with pressure gauge can be installed at any point between the pump and the first point of use, so that the direction of the arrow located on the underside of the device (near the thread) between the two 1" connections corresponds to the direction of water flow. The hydraulic connections must be perfectly sealed. If a pump with a maximum permissible pressure of 8 bar is used, a pressure reducing valve must be installed on the PC-13 inlet. The device is factory-set to 1.5 bar, which is optimal for most uses. Supplied with cables: 1m cable with plug for connection to the electrical mains 60cm cable for connection to the pump The automatic home water pump station VESSER JET 100A with PC-13 is supplied disassembled, allowing free placement of the control unit and/or filter. (Filter always before the control unit.) The automatic home water pump station VESSER JET 100A with BRIO PC-13 includes: Self-priming pump VESSER JET 100A BRIO PC-13 control unit