Automatic home water pump station VESSER JET 100A with PC-16

Product detailed description

The automatic home water pump station VESSER JET 100A with PC-16 is used mainly seasonally, primarily for irrigation. Use and advantages of the VESSER JET 100A pump: pumping from wells where the suction depth does not exceed 8 metres irrigation high discharge head corrosion resistant easy operation PC-16 control unit with pressure gauge: Provides dry-run protection - switches off the pump when running without water. This protects the pump from damage that could occur. After switching off, it is put back into operation by pressing the RESET button. We recommend using the PC-16 automatic device with pressure gauge in clean water systems without impurities and sediments, so please be sure to check the related products - filters. Product advantages: Versatility. If in the future you want to set up a home water pump station with a pressure vessel, the PC-16 will serve you as dry-run protection and a pressure switch. The IBO PC-16 control unit with pressure gauge has a built-in check valve against backflow of water into the pump. Operation and basic data: The PC-16 automatic device with pressure gauge starts the pump for approximately 15 seconds at the moment of connection. The pump then starts every time the operating pressure is reached, at the moment the pressure in the system drops, for example when a valve is opened. Unlike other pressure switches, which switch off when a certain pressure is reached, the PC-16 automatic device with pressure gauge switches off at the moment the minimum flow value is reached. When this condition is met, the device delays switching off the device by 7 to 15 seconds. This reduces the frequency of pump starts at low flow rates. Installation: The PC-16 automatic device with pressure gauge can be installed at any point between the pump and the first point of use, so that the direction of the arrow located on the underside of the device (near the thread) between the two 1" connections corresponds to the direction of water flow. The hydraulic connections must be perfectly sealed. If a pump with a maximum permissible pressure of 10 bar is used, a pressure reducing valve must be installed on the PC-16 inlet. The device is factory-set to 1.5 bar, which is optimal for most uses. After disconnecting the device from the electrical supply, if the hydraulic performance of the pump used allows it, the pressure can be changed by removing the top cover using the screw marked with + and - signs. Technical data: Power supply: 230V Max. current: 10A; 1.1kW Max. permissible pressure: 10bar Max. liquid temperature: 55°C Connections: inlet/outlet G 1" 1m cable with plug for connection to the electrical mains Plug for connecting the pump The automatic home water pump station VESSER JET 100A with PC-16 includes: Pump VESSER JET 100A PC-16 control unit The automatic home water pump station VESSER JET 100A with PC-16 is supplied disassembled, allowing free placement of the control unit and filter. (Filter always before the control unit.)