Automatic home water system AJ 50/60 with BRIO PC-13 IBO, 1100W, 3600 l/h, 50m head, stainless steel

Product detailed description

The AJ IBO automatic home water system with PC-13 is used mainly seasonally, especially for irrigation. Use: pumping from wells where the suction height does not exceed 8 metres supplying clean water to houses and cottages irrigation high delivery head corrosion-resistant easy operation BRIO PC-13 control unit: automatic pump switching on/off when the tap is opened/closed built-in check valve and integrated dry-run protection pressure gauge rated current: up to 10A operating voltage: ~230V ±10% / 50Hz connection: inlet and outlet each with 2.54 cm (G1") external thread maximum operating pressure: approx. 10 bar maximum water temperature: approx. 60°C switch reset: manual switch-on pressure range: 1.5 bar switch-off pressure setting not possible volume flow: approx. 150 litres/min dimensions (H x W x D): 15 x 13 x 23 cm weight: approx. 1.3 kg protection class: IP65 The electronic pump-run monitoring switch - the press control - performs the function of a pressure switch, enabling automatic operation of the electric water pump depending on the pressure drop and when water flow in the system stops (i.e. when the device's electrical contacts open and close) - it enables automatic operation of the pump or the water system. The PC-13 press control unit with pressure gauge also provides dry-run protection - it switches off the pump when it runs without water. After switching off, it is put back into operation by pressing the RESET button. We recommend using the PC-13 press control unit with pressure gauge in clean water systems free of dirt and sediment; otherwise a suitable filter should be installed on the inlet side of the device. A suitable alternative is also: the PC-16 control unit. Product advantages: The PC-13 press control unit with pressure gauge can be used as an automatic unit for pumps and water systems without a pressure tank (automatic water system). A major advantage of the PC-13 control unit is its ease of use. The BRIO PC-13 control unit with pressure gauge - press control - has a built-in check valve to prevent water flowing back into the pump. Operation and basic data: When first connected, the PC-13 unit with pressure gauge starts the pump for approximately 15 seconds. After that, the pump always starts when the operating pressure is reached, i.e. when the pressure in the system drops, for example when a valve is opened. Unlike other pressure switches and control units, which switch off once a certain pressure is reached, the PC-13 unit with pressure gauge switches off when the minimum flow value is reached. Once this condition is met, the device delays switching off by 7 to 15 seconds, which reduces how often the pump starts at low flow rates. Installation: The PC-13 unit with pressure gauge can be installed at any point between the pump and the first point of use, so that the direction of the arrow located on the underside of the device (near the thread), between the two 1" connections, matches the direction of water flow. Perfect sealing of all hydraulic connections must be ensured in the system. If a pump with a maximum permissible pressure of 8 bar is used, a pressure-reducing valve must be installed on the PC-13 inlet. The device is factory-set to 1.5 bar, which is optimal for most applications. Supplied with cables: 1m cable with plug for connection to the mains 60cm cable for connection to the pump The AJ IBO 50/60 automatic home water system with BRIO PC-13 includes: AJ IBO 50/60 pump PC-13 control unit The AJ IBO automatic home water system with PC-13 is supplied disassembled so that the control unit or filter can be positioned as desired. (The filter always goes before the control unit.)