Automatic Home Water System with Submersible Pump SCR-0.50 and ADARA 6 + Reducing Valve - RTS, Well Water Pump

Product detailed description

Automatic water system with the helical rotor pump SCR-0.50 made of AISI 304 stainless steel. The automatic home water system with submersible pump SCR-0.50 and ADARA 6 is used mainly seasonally, primarily for irrigation. The pump is built as a very robust, maintenance-free pump with a wide range of uses. With the ADARA 6 control unit, you do NOT need a pressure tank, pressure switch or dry-run protection. The SCR pump housing, neck, shaft, rotor and screws are made of AISI 304 stainless steel Advantages of the automatic water system with the ADARA 6 control unit The ADARA 6 unit allows you to set the switch-on pressure (0.5-6 bar) and switch-off pressure (0.8-9 bar). It allows connection with the pump even without an external pressure tank, functioning as an automatic unit. The ADARA 6 control unit itself has a built-in 0.3L pressure tank. It features simple and intuitive control. It guarantees simple and reliable performance. The control unit's pressure sensor has a fast response time and high accuracy. A highly sensitive display shows the measured pressure in real time. Another advantage of the control unit is energy-efficient operation. Built-in protective functions of the ADARA 6 control unit Dry-run protection - when there is no water in the well, the ADARA 6 control unit switches off the pump. This protects the pump from damage that could occur when running without water. Overload protection Protection against frequent switching on Pipeline overpressure warning Low water warning Operation of the water system with the helical rotor pump SCR-0.50 and the ADARA 6 control unit When used for irrigation, the control unit should be set to FLOW MODE: Once the pump starts, it will continue running as long as water is flowing in the pipeline. If no water flow is detected in the pipeline and the pressure in the pipeline is higher than the set starting pressure, the pump will run for 10 seconds and stop at the maximum pressure the pump can generate. If no water flow is detected in the pipeline while the pump is running and the pressure in the pipeline is lower than the set switch-on pressure, the control unit switches to dry-run protection mode and the pump stops. We recommend using the ADARA 6 control unit in clean water systems. For this water system to operate reliably, a reducing valve must be used in this set ahead of the ADARA 6 control unit: The reducing valve should be set to a max. pressure of 6 bar It should be installed at the inlet to the ADARA 6 control unit A 1" water reducing valve is included in the package. The automatic home water system with helical rotor pump SCR-0.50 and ADARA 6 control unit includes: Submersible pump SCR-0.50 ADARA 6 control unit Connection set for submersible pumps Brass nipple 1" Check valve 1" Adapter with external thread 32x1" Adapter with internal thread 32x1" 1" water reducing valve Suspension device for submersible pumps