CRANIT Flokul Ultra 0.5l Pool Water Clarifier

Product detailed description

Designed to remove water turbidity by flocculating impurities. Increases the efficiency of the sand filter and enables removal of the smallest particles from the water. Using this product makes the water clear and sparkling clean. It should be used when the pool water is cloudy even at correct pH and active chlorine values. Dosage is 3 – 6 ml of product per 1 m3 (1,000 liters) of water.
Instructions
Before using the product, adjust the water pH to approx. 6.8 using Cranit pH plus/Cranit pH minus. Mix the required dose of the product in 10 liters of water in a plastic container, start the filtration system and slowly pour it into the skimmer or spread it evenly over the surface. Let the filtration run for several hours to ensure thorough mixing of the product in the water, then let it stand (with the filtration system switched off) for approx. 10 hours. After this time, any precipitated impurities settled at the bottom of the pool can be removed with a submersible vacuum cleaner.
Dosage
3 – 6 ml of product per 1 m3 (1,000 liters) of water.
Hazard identification
Signal word: DANGER
H318 Causes serious eye damage.
P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P234 Keep only in original packaging.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P310 Immediately call a doctor.
P302+P352 IF ON SKIN: Wash with plenty of water.
P501 Dispose of contents/container at a location designated by the municipality for hazardous waste disposal.