Photovoltaic Solar Panel 12V/80W SZ-80-MC 760x600x2mm Monocrystalline Flexible

Product detailed description

The Solarfam photovoltaic panel is made of monocrystalline silicon. It is lightweight and semi-flexible, designed primarily for installation on slightly curved surfaces, e.g. on boats or caravans. It is equipped with 90 cm long cables with MC4 connectors. It is designed for a system voltage of 12V, and with regard to the Vmp parameter, for MPPT controllers.
Fully waterproof panel construction.
CPC
The CPC material used on the surface has good weather resistance and high light transmittance, and its performance is better than that of ETFE material. The integration of the composite material provides better protection of solar cells compared to traditional flexible panels. The panels are very light, easy to carry and install.
Technical parameters:
Maximum open circuit voltage Voc = 22.44 V
Max. short-circuit current Isc=4.43A
Maximum voltage at 80 W output: Vmp=19.14 V
Max. current at 80W: Imp=4.18A
Operating temperature: -40°C to +80°C
Number of cells: 33
Max. system voltage: 200V
Cable length: 90cm/2.5mm2
MC4
Dimensions: 760x600x2mm
Weight: 1.81 kg
Protection: IP67
CE, RoHS
Description of the monocrystalline cell
To produce a monocrystalline cell, it is necessary to manufacture a uniform quartz crystal ingot. Such production is quite demanding. The round ingot is cut into so-called wafers, which are trimmed to the required size of the photovoltaic cell. Since the ingot is formed as one large silicon crystal, its structure is uniform and very pure.
Advantages of monocrystalline
Higher cell efficiency, and therefore higher output from the same area
Slightly slower "aging" of the silicon, i.e. the panel's output decreases more slowly over time
The coloring of the cells is homogeneous, the panels are not "spotty"
Installation
When gluing the flexible panel to the roof of a vehicle, caravan, etc., it is necessary to take into account the different expansion rates of the roof and the panel material, which can cause damage to the flexible panel.
We recommend gluing flexible panels onto a "Makrolon Plexiglas" interlayer, which also allows air to flow under the solar panel, thereby increasing its efficiency. Note: the flexible panel can only be bent on the longer side and at an angle of maximum 20°.