Pressure Vessel AQUA OLA 50 L, Horizontal, for Home Water Systems and Pumps

Product detailed description

The AQUA OLA 50 L horizontal pressure vessel serves as a reservoir for pumped water for home water systems, transfer and pressure-boosting stations, or industrial stations. The AQUA OLA pressure vessel is designed for customers who don't settle for compromises or half-measures in usability. The quality of manufacturing of the entire product - the steel AQUA OLA pressure vessel - is underlined by an extended 3-year warranty. Features of the horizontal AQUA OLA 50 L pressure vessel: The pressure vessel can be paired with all types of pumps that do not exceed the vessel's maximum working pressure (10 bar). The pressure vessel contains a rubber (EPDM) bladder intended for drinking water. The factory pre-charge pressure is 2 bar. In general, the larger the installed pressure vessel, the fewer pump start cycles occur, and the longer the service life of the entire system. For pressure vessels with a rubber bladder, it is recommended to check the air pressure in the vessel approximately once every 6 months. When installing a pressure vessel with a rubber bladder, there is no need to deal with the required air intake into the vessel, eliminating the associated higher maintenance demands of the equipment. Most frequently asked question: What exactly does Pressure (bar) mean - PS pressure and MAX pressure. This is a relative expression of pressure, usually the pressure inside an enclosed space (in our case, the pressure vessel) relative to the pressure of the surrounding space (often atmospheric). PS is the working pressure and indicates the highest working pressure at which the pressure vessel can function correctly over the long term; it is measured in bar. For example, in households the system pressure should not exceed roughly 4 to 4.5 bar, and even these values are already at the limit. Most commonly, the pressure system in family homes stays below 3.8 bar. Higher set pressure values in the house can, in the long run, cause problems, affecting various valves and mixer taps in particular. MAX pressure marked on the pressure vessel indicates the pressure at which the vessel was tested at the factory. The overall integrity and strength of the vessel, including the strength of its welds, is tested. The test is carried out without the bladder inserted. POZOR! You must not apply a pressure of 15 bar to the pressure vessel - it would not work. The bladder would expand until it completely filled the inside of the vessel, and after a few cycles it would burst. Technical data sheet: