Siemens RDE 410/EH

Product detailed description

Two-position heating control Siemens RDE 410/EH

• Supply voltage: AC 230V
• 2-position control with output: On / Off
• Maximum load: 16 A
• Protection rating: IP31, suitable for installation in damp rooms
• Input for wired temperature sensor: NTC 3kOhm (QAP1030 / UFH) for floor temperature sensing
• Floor temperature limitation with wired temperature sensor
• Operating modes: comfort, setback and protection mode
• Limiting the maximum or minimum adjustable setpoint temperature
• Backlit display
• Suitable for round electrical installation boxes: according to CEE / VDE (min. depth 40 mm)
• Automatic mode with 8 programmable time blocks

• Room temperature control with built-in or separate temperature sensor
• Selecting the operating mode using the button on the controller
• Display of the current room or setpoint temperature in °C
• Limiting the maximum or minimum adjustable setpoint temperature
• Locking the controls (automatic or manual)
• Floor temperature limitation with wired temperature sensor
• Backlit display
• Reset to factory default configuration and control parameters
• Time program: 8 programmable weekly time blocks for switching between comfort and energy-saving operation (RDE410/EH only)

Frequently Asked Questions

• How exactly does a manual (simple) thermostat work? It measures the temperature at its installation location and, when it drops below the set value, closes a contact that activates the heat source (boiler, pump, heating unit) - once the set temperature is reached, the contact opens again. Unlike programmable thermostats, it has no weekly or daily program; the temperature is set manually using a rotary or slide control.
• Where should the thermostat be placed? In a location that best represents the typical room temperature - away from direct sunlight, drafts, radiators, or other heat/cold sources that could distort the reading.
• Must installation be carried out by an electrician? Connecting the thermostat to the electrical circuit of the heat source should be done by a person with electrical qualifications, as it involves working on the electrical installation and load switching.