OMNIGENA 40-80 180mm
Code: OMNIGENA 40-80 180MMRelated products
Product detailed description
Circulation pump OMNIGENA 40-80 180mm
- The OMNIGENA series of solar pumps is designed for water circulation in solar and heating systems.
- The pumps can operate in water systems and circuits containing water-glycol mixtures in a 50/50 ratio.
- The maximum temperature of the water / water-glycol circuit must not exceed 120°C and must not be lower than 5°C
- The pumps cannot operate in water systems or circuits that contain water-glycol and may contain solid particles (e.g. pieces of rust, etc.).
Pump installation
- It is recommended to install the pump on the return pipe. Ball valves or a filter should be installed immediately before and after the pump.
The pump must be installed so that:
- The required water flow direction is in accordance with the arrow shown on the pump housing.
- The circulation pump must always be in a horizontal position. Setting the pump axis in a different position will lead to premature wear of the bearing and pump block.
- The electronics must not be placed below the pump - any water condensation from the motor housing could flood the electrical connections, leading to failure; pump failure that causes flooding of the terminal box is not covered by the warranty.
- The room where the pump will be installed should not have excessive humidity.
- The pump should be easily accessible for maintenance and bleeding.
Before starting, make sure the system is filled with water or glycol - the pump must not run "dry". Running "dry" will destroy the pump. Before starting the pump, set the speed to the highest (fastest) setting III, open the drain screw located on the back of the motor housing, and switch on the pump. If air particles are present in the water flow, the pump needs to be bled.
Pump operation and maintenance
The device only requires checking the pump when putting it into operation, or after a longer period of inactivity (e.g. before the heating season). After a long period of rest, check that the motor shaft is not blocked. This should be done as follows: open the bleed screw. At the end of the opening you will see the end of the shaft with a cross-cut. Using a flat screwdriver, turn the shaft in the direction indicated on the pump housing. After performing these operations, tighten the bleed screw and start the pump at the highest speed setting.
Composition:
- pump housing made of cast iron, impeller made of noryl, ceramic shafts
Features and benefits:
- adjustable speed (3 levels)
- quiet operation
- standard installation dimensions
- robust construction
- reliable and easy operation
TYPE | Maximum speed [1/min] | Water head [m] | Motor power [W] | Consumption [A] |
OMIS 40-80/180 | 170 | 8 | Level I – 150 Level II – 220 Level III - 270 | Level I – 0.7 Level II – 1.1 Level III – 1.22 |
Additional parameters
| Category: | OMNIGENA |
|---|---|
| Warranty: | 2 years |
| Weight: | 3 kg |
| Product replaced by new one: | https://www.atria.sk/avansa-32-6-180/ |
| The item has been sold out… | |
Product rating
Be the first who will post an article to this item!
Discussion
Be the first who will post an article to this item!