Assembly manifold/collector for heating radiators - without cabinet - 1xEK; 6-way; nickel

Code: 551754N

napojeny tovar

Not rated Rating details

Brand: IVAR

322,26 € –20 %

24905 zostava rozdelovac zberac pre vykurovacie telesia bez skrine 1xek 6cestny nikel

24905 1 zostava rozdelovac zberac pre vykurovacie telesia bez skrine 1xek 6cestny nikel

322,26 € –20 % 257,81 € / pcs

1 week

Detailed information

22034 1 zverne srobenie na viacvrstvove potrubie alpex 16x2 alu ek

Action

–19 %

Compression fitting - for ALPEX multilayer pipe - 16x2 ALU-EK

In stock now (1831 pcs)

3,70 €

Compression fitting - for ALPEX multilayer pipe - 16x2 ALU-EK

500684

–37 %

Pipe calibrator

In stock now (25 pcs)

15,87 €

Pipe calibrator for PEX-AL-PEX pipe 16 mm / 20 mm / 26 mmA tool for calibrating...

KALIBRATOR NA POTRUBIE

–17 %

System insulation board UHP55 for underfloor heating (STIROTERMAL BASIC)

(0.004 m2)

11,72 €

System insulation polystyrene board UHP55 (STIROTERMAL BASIC) with increased...

STIROTERMAL BASIC

Action

–31 %

Avansa 2007 TX

In stock now (28 pcs)

56,31 €

The wireless thermostat Avansa 2007 TX is suitable for controlling most boilers....

BEZDROTOVY TERMOSTAT AVANSA 2007TX

Show all related products

Product detailed description

Assembly manifold for heating radiators - without cabinet, IVAR.CS 501 ND, size: 1" x EK, 6-way, cabinet: P2/N2

PN 10, T = +120 °C
the set includes: manifold and collector, mounting brackets, inlet ball valves, end fitting with automatic air vent valve and rotary drain valve, and plugs
side inlets 1" F
outlets 3/4" EK
outlet spacing 50 mm
plugs 1/2"
material: nickel-plated brass CW617N

Set for radiator heating or sanitary distribution, without a pump.

Recommended for a of the radiator part of the system +75 ˚C / +65 ˚C

Fitted circulation pump: without pump (not is needed, since pump replaces boiler)

Note: The seller is not responsible for functional defects caused by impurities in the system.

Before every commissioning heating's system, especially with combination underfloor a radiator heating, strongly it is necessary flushing whole system according to instructions manufacturer's. We recommend treatment system with the product GEL.POLY AP.

Manifold sa are placed into skriniek, their recommended lengths are listed v table manifolds. Fitting manifolds v highest mieste is prakticky podmienkou (pozor for level zmeny v floor plans). Exception is venting small floor loops in higher storey via bathroom towel radiator. If sa vyhotovuje floor system iba v bathrooms, is possible use pipe zo return vetvy radiator system s polyethylene conduit or sa is used for konci tejto paralelnej loop direct-acting regulator temperature, which will ensure vychladenie for low-temperature level (pozor! Is necessary its oddelenie from return pipe radiator circuit, so that nebol tepelne affected).

For further information you can go to the questions and answers at https://www.systemova-doska.sk/podlahove-heating/