Assembly manifold/collector - without cabinet - 1xEK; 4-way; nickel

Before every commissioning of the heating system, especially when combining underfloor and radiator heating, it is strongly recommended to flush the whole system according to the manufacturer's instructions. We recommend treating the system with the product GEL.POLY A.P.

Manifolds are installed in cabinets; their recommended lengths are given in the manifold table. Fitting the manifolds at the highest point is practically a requirement (watch out for level changes in the floor plan). The exception is venting small floor loops on a higher storey via a bathroom towel radiator. If the floor system is installed only in bathrooms, it is possible to use a pipe from the return branch of the radiator system with a polyethylene conduit, or a direct-acting temperature regulator can be used at the end of this parallel loop, which will ensure cooling to a low temperature level (caution! it must be thermally separated from the return of the radiator circuit with that it is not thermally affected).

For further information you can go to the questions and answers at https://www.systemova-doska.sk/podlahove-heating/