DUAL - assembly for combined heating - without cabinet - 3/4"xEK; 10-way; brass
Code: 557678KSRelated products
Product detailed description
IVAR.CI 557 KS Manifold Assembly, size: 3/4" x EK, 10-way
- DUAL - assembly for combining underfloor heating with radiator heating
- PN 6, T = +90 °C
- connection thread, female 3/4” F
- material: brass CW617N
The assembly includes:
- manifold with flow meters
- collector with shut-off valves
- mounting brackets
- thermostatic valve with thermostatic head and separate immersion temperature sensor for constant-temperature control
- balancing fitting
- circulation pump with wiring
- safety thermostat
- 2 pcs automatic air vent valves
- thermometer
- 2 pcs rotary drain valves
Recommended for a radiator-circuit temperature gradient of +75 °C / +65 °C
Fitted with circulation pump: DAB.EVOSTA 2 40-70/130
Switching the circulation pump off is not part of the manifold assembly; it can be handled by a higher-level controller or by the IVAR.AC 614 E circulation-pump control thermostat.
Pump rotated to the front position A = 165, installation depth = 160 mm
Pump rotated to the side position A = 220, installation depth = 132 mm
Note:
The thermostatic valve at the assembly's inlet can alternatively be replaced with a thermostatic valve with Vats flow, Kv, type VDS 01, 02.
Caution:
- the flow meter is integrated into the balancing fitting on the inlet water
- the assembly is NOT intended for use in combination with a condensing boiler or a heat pump
- the seller is not liable for functional faults caused by contamination in the system
Notice:
Before commissioning the heating system, especially when combining underfloor and radiator heating, it is strongly recommended to flush the entire system according to the manufacturer's instructions. We recommend treating the system with GEL.LONG LIFE 100.
Manifolds are installed in cabinets; their recommended lengths are given in the manifold table. Installing the manifolds at the highest point is practically a requirement (watch for level changes in the floor plan). The exception is venting small underfloor loops on a higher floor via a bathroom towel radiator. If the underfloor system is used only in bathrooms, you can use piping from the return branch of the radiator system with a polyethylene sleeve, or fit a direct-acting temperature regulator at the end of this parallel loop, which ensures cooling to a low-temperature level (caution! it must be thermally separated from the radiator circuit return so that it is not thermally affected).
For further information you can go to the questions and answers at https://www.systemova-doska.sk/podlahove-vykurovanie/
Additional parameters
| Category: | IVAR.CI 557 KS with pump |
|---|---|
| Warranty: | 2 years |
| Weight: | 13.85 kg |
| EAN: | 8595145900725 |
| Nominal pressure: | PN 6 |
| Last price update: | 13.04.2026 1:07:06 |
Product rating
Be the first who will post an article to this item!
Discussion
List of discussions
M
michal
michal
Dobry den, mozem sa spytat preco nie je takato zostava vhodna k TC? Dakujem.
AK
Adrian Kapustík
Adrian Kapustík
Dobrý den, mame problem so zopinanim cerpadla na podobnej zostave. Ked cerpadlo napojim na priamo na 24Ov tak ide bez problemov ale ked je napajane z tej ciernej skrinky, ktora je zrejme kontrolovana ventilom?!? tak sa nikdy nezopne. Mal by to byt nejaky bezpecnostny ventil ktory kontroluje zopnutie cerpadla alebo ho zopina len v pripade poklesu teploty? neviem nikto nam v tom nevie poradit. Rad by som kupil ten ventil samostatne ale neviem kde a ako sa to vola? dakujem. A.K.
A
ATRIA
ATRIA
Dobrý deň. Tiež si myslím, že to môže byť v tom poistnom ventile. Každopádne radšej sa ešte poradte s pánom, ktorý ho montoval, dostupné sú tu. https://www.atria.sk/vykurovacia-technika/kurenie-profesionalne/rozdelovace-a-pod-vykurovanie/systemove-izolacne-dosky/prislusenstvo-k-system-doskam/. Pekný deň.